Ruby Dr dabber Switch 2 prototype Insert

All sold, considering preorders for another ? Message Ruby V3 prototypes are in. Extra mass is doing work of providing an extra hit or two post timer shut off. 420–440°F more visible clouds on low temp than I expected, I expected thicker walls to affect this more. I found my preferred setting to use this on valley mode at 480-490f. I shred dabs too fast over 500f higher than this Vs sapphire: no etching (easier to clean), 20% smaller air holes for more restriction, thicker walls. tolerance is 1/16 it’s not the manufacturer’s fault. ruby and sapphire are both corundum, but the sapphire used in inserts theorized to be molded which is better tolerances on final shape. The shaping cutting down is where we met some challenges. 1/16 is the bottom for machined ruby at this point.  You might...